Optimization of the electrical signal generation of a microbial fuel cell for sensor applications

Duan Dong Ta¹, Hai The Pham^{1, 2*}

¹GREENLAB - Center for Life Science Research (CELIFE), Faculty of Biology, VNU University of Science (Vietnam National University, Hanoi)

²Department of Microbiology, Faculty of Biology, VNU University of Science (Vietnam National University, Hanoi)

Received 20 September 2019; accepted 20 December 2019

 

Abstract:

In previous studies, a microbial fuel cell (MFC) was developed as a potential sensor that detects iron in water. However, to realize such an application in practice, the MFC’s electrical signal generation must be improved. Therefore, in this study, we investigated several measures to optimize the electrical signals of the MFC including (i) changing the anode spacing, (ii) testing different oxygen supply rates, (iii) testing different external resistances, and (iv) testing a new electrode material. An anode spacing of 2 cm was found to be optimal as the MFC generated a current that was at least 2-fold higher than any other anode spacing investigated. To limit oxygen diffusion from the cathode to the anode, an optimal cathode air flow rate of 1.8 ml min^-1 was found, which corresponds to an oxygen supply rate of 0.286 mg min^-1. By a polarization experiment, a 60-Ω external resistance ensured the most stable MFC-generated current, which is compulsory for the device’s use as a biosensor. Finally, activated carbon was shown to be an excellent material to improve electrical signal generation by 2-fold in comparison with graphite felt and graphite granules. These reported results will be the basis of further development of the MFC toward a practical biosensor.

Keywords: anode spacing, electrode material, external resistance, microbial fuel cell biosensor, oxygen supply rate.

Classification number: 3.5